Fast and durable cut edge corrosion system
No application should proceed during inclement weather or if this could occur within 20 minutes of application. The substrate must be free from ice, frost and any contamination.
Peel and cut back any loose plastisol coating, and where required sand back to a feathered edge. Mask off the outside top and bottom edges to 100mm beyond the highest and lowest affected points of the damaged sheet.
Edge Armour Application
Edge Armour is an MMA based rapid cure system that will usually cure within 30 minutes of mixing in the catalyst. Stir contents of unit for 30 seconds, then add the pre-weighed catalyst and mix for a further 30 seconds. Apply with Alltimes Coatings Rollers or Rapid Applicator Brush. Gridding the area is recommended to ensure coverage is achieved and to avoid wastage.
Edge Armour Coverage Rates
Edge Armour 10 Year - nominal coverage 1.5kg/m2
Edge Armour 15 Year – nominal coverage 1.75kg/m2
Cleaning: All tools and equipment should be cleaned before the material is allowed to cure. Clean using AT Tool Cleaner.
Light foot traffic: 2 hours @ 20°C
Full chemical resistance: 24 hours @ 20°C
Colours: Edge Armour is available in White, Light, Medium and Dark Grey.
Storage: Store in dry, cool conditions, preferably at temperatures between 10°C and 20°C.
Edge Armour - 2.5kg & 5kg units
AT Glassmat 100 – 250mm x 20m
For further information please refer to: CE Certificate, Data Sheet, MSDS (Material Safety Data Sheet)
Drying times can be effected by Temperature, Lack of air flow, ponded water or application coverage, please apply within the above parameters.
All products should be sold in accordance with the manufacturer’s instructions. No responsibility can be taken by the manufacturers where conditions of use are beyond our control.